TM 11-5820-765-34
Section I. GENERAL INFORMATION
3-1. GENERAL
Low voltage, high amperage current is present at output connections and
connections
inside
equipment.
Shut off power supply before performing maintenance.
Be careful when working with 115 or 230-volt ac line connections.
Serious injury or death may result from contact with terminals.
This chapter covers general support troubleshooting, maintenance, and testing procedures for
the power supply. Section I lists the tools, test equipment, and materials needed to perform
general support maintenance. Troubleshooting procedures are described in
Section
II,
maintenance procedures in Section III, and test procedures in Section IV.
NOTE
This chapter is confined to maintenance of circuit card assembly
PC101(A1). For all other maintenance instructions, see Chapter 2.
3 - 2 . REPAIR PARTS, TOOLS, TEST EQUIPMENT, AND MATERIALS
Repair Parts: Refer to TM 11-5820-765-34P-1.
Special Tools: No special tools are needed.
Tools, Test Equipment, and Materials:
National Stock Number
Item
TOOLS
Tool Kit, Electronic Equipment TK-100/G
Tool Kit, Electronic Equipment TK-105/G
5120-00-230-6380
Torque Wrench, 150 inch-pounds
TEST EQUIPMENT
TS-352B/U
ZM-21A/U
AN/USM-281A
6120-00-503-0632
Variable
Power
TF-171/USM
Electronic
AN/USM-98A