TM 5-1730-245-14
Figure 6-5. Fuel Injector Pump.
Figure 6-6. Fuel Pump Tappet.
CAUTION
Before installing fuel pump the governor stop/run lever must be correctly
adjusted if the governor has been removed or is known to be out of
been removed. It must be replaced with the longer slot facing outwards to
ensure that it is correctly located over the end of the stud (1, fig 6-6).
NOTE
Use the flywheel locking tool to retain the flywheel while loosening the bolt.
1) Remove center bolt (4) which has a left hand thread and crankshaft pulley (5).
2) Remove the gear end cover (7), gear end oil seal (6) and gasket (8) to expose the governor
mechanism.
Figure 6-7. Gear End Cover
6-9