TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
ad. Remove low pressure filter head
Remove and discard copper
fold (78).
seal.
(1) Trace three blue wires from
(2) Withdraw tube assembly (52,
head assembly (22) to terminal board
Tag and disconnect leads
panel (39).
connect (34), from module.
from terminal board and clip wire ties
as needed to free leads from module
ag. Label (with terminal board and
terminal designator) each wire between
harness.
front panel (33, figure 8-14) and ter-
minal board panel (39) and disconnect
(2) support head assembly (22) to
wires from terminal boards.
prevent drop and damage.
ah. Remove fill, temperature sensor,
(3) Remove three bolts (75) that
secure head assembly (22) to frame.
(4) Withdraw head assembly (22)
from module.
(1) Trace each of the three wires
from each of the four temperature sen-
sors (79) to the terminal boards on
panel (39). Clip wire ties as necessary
to separate wire from module harness.
(1) Trace three blue wires from
(2) Label each wire with the ter-
head assembly (27) to terminal board
Tag and disconnect leads from
minal board and terminal designator.
(39).
terminal board and clip wire ties as
(3) Loosen the terminal board
needed to free leads from module har-
screw and remove each temperature sensor
ness.
wire.
(2) Support head assembly (27) to
(4) Tilt module (about 30 degrees)
prevent drop and damage.
to its right to gain access to holes un-
derneath - block module for support and
(3) Remove three bolts (76) that
to prevent slippage.
secure head assembly (27) to frame.
(4) Withdraw head assembly (27)
(5) Remove four socket head cap-
from manifold.
screws (80) that hold reservoir select
manifold (58) to module frame (l).
af. Remove tube assembly (52, figure
(6) Remove supports and restore
module to normal position.
(1) Remove connector of tube as-
(7) Withdraw aassembled manifold
group (51, 78, and 58) from module.
on back of the temperature sensor mani-
8-35