TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(3) Install new copper seal (7C-
(5) Install lower connector of
tube assembly (1) on fitting (65, figure
8-14) on
back of
main control manifold
control manifold's right side.
(15). Tighten hand tight.
(4) Insert tube assembly (11, fig-
m. Install tube assembly (8, figure
(5) Install tube assembly (11)
(1) Inspect threads at both ends
on main control manifold's right side.
of tube assembly (8) and elbow fitting
Tighten hand tight.
tamination.
o. Install reservoir (11) into mod-
ule frame (1) as follows:
(2) Coat threads of both ends of
(1) Inspect threads on bulkhead
hydraulic fluid (MIL-H-5606 or MIL-H-
fittings (55, 56, and 59) for damage and
83282).
(3) Install new copper seal (7C-8)
on side port of swivel nut tee (49) and
another on elbow fitting (64, figure
Use extreme care in the following
step not to damage threads of
(4) Insert tube assembly (8, fig-
bulkhead fittings under reservoir.
near swivel nut tee (49) and shorter leg
insert
reservoir
(2) Carefully
(11) into module through module left
top of main control manifold (15).
side.
(5) Install tube assembly (8, fig-
(3) Install and tighten four bolts
(49). Tighten hand tight.
(18) and nuts (62) that insert ver-
tically through reservoir flanges and
module frame at each corner of reser-
(6) Install tube assembly (8) con-
nector on elbow fitting (64, figure
voir.
8-14) on
top of
main control manifold
(15). Tighten hand tight.
(4) Install and tighten four bolts
(60) and washers (61) that insert hori-
zontally through module frame and into
n. Install tube assembly (11, figure
reservoir brackets at center front and
center rear.
(1) Inspect threads of both ends
(5) Install new copper seal (7C-8)
of tube assembly (11) and fitting (63,
on center bulkhead fitting (59) under
reservoir (11).
(6) Install nut of swivel tee (49,
(2) Coat threads of both ends of
tube assembly (11) with hydraulic fluid
(MIL-H-5606 or MIL-H-83282).
between 450 and 500 inch-pounds.
8-39