TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
center bolt. Secure rear axle assembly
by installing bolts (4), washers (3) and
and washers (3).
nuts (2).
(9) Remove bolts (4) and plate
(4) Remove support fitted in para-
(5).
graph a. (10).
(10) Place a suitable length of 4 x
(5) Connect two hardwires to elec-
2 between motor mounting plate and rear
axle assembly. Ensure load is not ap-
tric brake with butt splices.
NOTE
(11) Ensuring that rear axle as-
sembly is fully supported and not ob-
structed, slowly raise rear of AGPU
In connecting electric brake,
observance of polarity is not
until sufficient clearance is obtained
required.
for removal of rear axle assembly.
(6) Connect four wires (11) to
(12) While continuing to support
traction motor (8) by installing lock-
rear axle assembly, remove rear axle
washers (9) and nuts (10). Remove tags.
assembly and support on 4 x 2 with
Connect two hardwires with butt splices.
clutch lever uppermost.
(7) Install clutch assembly engage/
under fork
(13) Position supports
disengage microswitch in accordance with
lift beams.
Install. (See figure 10-14.)
b.
parking
brake in
(8) Connect
accordance with TM 55-1730-229-12, para-
graph 4-114.
The rear axle assembly is top
(9) Connect battery.
heavy and will rotate on wheel
(10) Apply power to the drive sys-
injury to personnel or damage to
tem in the alternate propulsion mode
equipment, ensure rear axle assem-
(TM 55-1730-229-34). Functionally check
bly is fully supported during the
electric brake by pressing
dead-man
following procedures.
switch and listening for an audible
click from electric brake.
(1) Ensuring there is no obstruc-
tion, position rear axle assembly under
10-9.
SPRING ASSEMBLY, FRONT/REAR.
AGPU aligning mounting pad (7) with rear
springs.
Remove Front Spring Assemby.
(2) Remove supports and
slowly
lower AGPU and ensure spring center
(1) Position AGPU on level sur-
bolts engage center hole in mounting
face. Chock rear wheels.
pad (7).
(2) Remove front wheels in accord-
(3) Install plates (5) ensuring
with paragraph 4-112, TM 55-1730-229-12.
center hole in plate engages spring
10-24.1 (10-24.2 Blank)
Change 2