TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
NOTE
d. Perform the D (during) operator
PMCS contained in table 3-2 of TM 55-
The use of hot section components
1730-229-12 during performance tests
outlined in paragraphs e. through i.
will be extended by operating the
engine at no-load governed speed
for at least one minute prior to
e. Perform AC Mode Operation proce-
dures contained in chapter 2 of TM 55-
application of a bleed-air load.
1730-229-12.
NOTE
f. Perform DC Mode Operation proce-
dures contained in chapter 2 of TM 55-
1730-229-12.
The use of hot section components
will be extended by operating the
engine at or below the maximum ex-
g. Perform Bleed Air (Pneumatic)
haust gas temperature limit.
System Operation procedures contained in
chapter 2 of TM 55-1730-229-12.
(2) Ensure that engine operates at
h. Perform Hydraulic System Opera-
tion procedures contained in chapter 2
or below maximum exhaust gas temperature
limit of 1255F (680C) during load
of TM 55-1730-229-12.
operations.
i. Perform Propulsion System Opera-
tion procedures contained in chapter 2
NOTE
of TM 55-1730-229-12.
When loads are removed and engine
j. Perform Removing AGPU From Op-
eration and Placing AGPU in Shutdown
is to be shut down, the customary
three-minute "cool-down" run at
Status procedures contained in chapter 2
of TM 55-1730-229-12.
no-load used on other gas turbine
engines is not desired for the
AGPU engine and will detrimentally
k. Perform the A (after) operator
affect the life of hot section
PMCS contained in table 3-2 of TM 55-
1730-229-12.
components.
Table 11-1.
Engine Operating Limits
Limit Requirements
Condition
Observation
Shut down engine if indicated values exceed or persist at these
limits.
Pressure:
Oil
45 +10/-10 psig
Governed speed
+5/-5 psig max
Steady-state
fluctuation
11-2