C4, TM 11-5820-765-12
APPENDIX A
REFERENCES
(CONT'D)
Consolidated Index of Army Publications and Blank Forms.
DA Pam 310-1
Painting and Preservation of Supplies Available for Field Use
SB 11-573
for Electronics Command Equipment.
Preservation, Packaging, Packing and Marking Materials,
SB 38-100
Supplies, and Equipment Used by the Army.
Tool Kit, Electronic Equipment TK-101/G (NSN 5180-00-
SC 5180-91-CL-R13
064-5178).
Field Instructions for Painting and Preserving Electronics
TB 43-0118
Command Equipment Including Camouflage pattern Painting
of Electrical Equipment Shelter.
Operator's and Organizational Maintenance Manual: Multi-
TM 11-6625-203-12
meter AN/URM-105 and AN/URM-105C (Including Multi-
meter ME-77/U and ME-77C/U).
The Army Maintenance Management System (TAMMS).
TM 38-750
Procedures for Destruction of Electronics Materiel to Prevent
TM 750-244-2
Enemy Use.
Page B-1.
Appendix B is superseded as follows:
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
B-1. Scope
This manual is your authority to requisition
replacement BII, based on TOE/MTOE authoriza-
This appendix lists integral components of and
tion of the end item.
basic issue items for the PP-4763/GRC to help you
B-3. Explanation of Columns
inventory items required for safe and efficient
operation.
a. Illustration. This column is divided as fol-
B-2. General
lows:
(1) Figure number. Indicates the figure num-
This Components of End Item List is divided into
ber of the illustration on which the item is shown.
the following sections:
(2) Item number. The number used to identify
a. Section II. Intergral Components of the End
item called out in the illustration.
Item. These items, when assembled, comprise the
b. National Stock Number. Indicates the Na-
PP-4763/GRC and must accompany it whenever it
tional stock number assigned to the item and
is transferred or turned in. The illustrations will
which will be used for requisitioning.
help you identify these items.
b. Section II. Basic Issue Items. These are the
c. Description. Indicates the Federal item name
minimum essential items required to place the PP-
and, if required, a minimum description to identify
4763/GRC in operation, to operate it, and to per-
the item. The part number indicates the primary
form emergency repairs. Although shipped sepa-
number used by the manufacturer, which controls
rately packed they must accompany the PP-4763/
the design and characteristics of the item by means
GRC during operation and whenever it is trans-
of its engineering drawings, specifications, stand-
ferred between accountable officers. The illustra-
ards, and inspection requirements to identify an
tions will assist you with hard-to-identify items.
item or range of items. Following the part num-
5
