TM 11-6130-243-24P
4606/G and its components:
used by the manufacturer (individual, company,
TM 11-6130-243-12 Power Supply PP-4606/G
firm, corporation, or Government activity), which
TM 11-6130-243-35, Power Supply PP-4606/G
controls the design and characteristics of the item
by means of its engineering drawings, speci-
5. How to Locate Repair Parts
fications, standards, and inspection requirements
a. When National stock number or part number
to identify an item or range of items.
NOTE
is unknown
(1) First. Using the table of contents, deter-
W h e n a stock numbered item is re-
mine the functional group within which the item
quisitioned, the repair part received may
belongs. This is necessary since illustrations are
have a different part number than the
prepared for fictional groups and listings are di-
part being replaced.
e. Federal Supply Code for Manufacturer
vided into the same groups.
(FSCM). The FSCM is a 5-digit numeric code listed
(2) Second. Find the illustration covering the
functional group to which the item belongs.
in SB 708-42 which is used to identify the manufac-
(3) Third. Identify the item on the illustration
turer, distributor, or Government agency, etc.
f. Description. Indicates the Federal item name
and note the illustration figure and item number of
the item.
and, if required, a minimum description to identify
(4) Fourth. Using the Repair Parts Listing,
the item.
g. Unit of Measure (U/M). Indicates the standard
find the figure and item number noted on the illus-
tration.
of the basic quantity of the listed item as used in
b. When National stock number or part number
performing the actual maintenance function. This
measure is expressed by a two-character alphabet-
is known.
(1) First. Using the Index of National Stock
ical abbreviation (e.g., ea, in, pr, etc). When the unit
Numbers and Part Numbers, find the pertinent
of measure differs from the unit of issue, the lowest
National stock number or part number. This index
unit of issue that will satisfy the required units of
is in NIIN sequence followed by a list of part num-
measure will be requisitioned.
bers in alphameric sequence, cross-referenced to
h. Quantity Incorporated in Unit. Indicates the
the illustration figure number and item number.
quantity of the item used in the breakout shown on
(2) Second. After finding the figure and item
the illustration figure, which is prepared for a
number, locate the figure and item number in the
functional group, subfunctional group, or an as-
repair parts list.
sembly.
6. Abbreviations
4. Special Information
Not applicable.
The following publications pertain to the PP-
(Next printed page is 4)
2
