TM 11-6130-369-40P
SECTION I
INTRODUCTION
1.
Scope
This manual lists spares and repair parts; special tools; special test, measurement, and diagnostic equipment (TMDE) ,
and other special support equipment required for performance of general support maintenance of the PP-6187/TSW-7. It
authorized the requisitioning and issue of spares and repair parts as indicated by the source and maintenance codes.
2.
General
This Repair Parts and Special Tools List is divided into the following sections:
a.Section II. Repair Parts List. A list of spares and repair parts authorized for use in the performance of
maintenance. The list also includes parts which must be removed for replacement of the authorized parts. Parts lists are
composed of functional groups in numeric sequence, with parts in each group listed in figure and item number sequence.
b.Section III. Special Tools List. Not applicable.
c.Section IV. National Stock Number and Part Number Index. A list, in National item identification number (NIIN)
sequence, of all National stock numbers (NSN) appearing in the listings, followed by a list, in alphameric sequence, of all
part numbers appearing in the listings. National stock numbers and part numbers are cross-referenced to each illustration
figure and item number appearance.
3.
Explanation of Columns
Illustration. This column is divided as follows:
a.
(1) Figure number. Indicates the figure number of the illustration on which the item is shown.
(2) Item number. The number used to identify item called out in the illustration.
b. Source, Maintenance, and Recoverability (SMR) Codes.
(1) Source code. Source codes indicate the manner of acquiring support items for maintenance, repair, or
overhaul of end items. Source codes are entered in the first and second positions of the Uniform SMR Code format as
follows.
Code
Definition
PA -
Item procured and stocked for anticipated or known usage.
XA
Item is not procured or stocked because the requirements for the item will result in the replacement of the next
higher
assembly.
XB
Item is not procured or stocked. If not available through salvage, requisition.
XD
A support item that is not stocked. When required, item will be procured through normal supply channels.
NOTE
Cannibalization or salvage may be used as a source of supply for any items source coded above Except those coded XA
and aircraft support items as restricted by AR 700-42.
(2) Maintenance code. Maintenance codes are assigned to indicate the levels of maintenance authorized to
indicate the levels of maintenance authorized to USE and REPAIR support items. The maintenance codes are entered in
the third and fourth positions of the Uniforms SMR code format as follows:
(a) The maintenance code entered in the third position will indicate the lowest maintenance level authorized
to remove, replace, and use the support item. The maintenance code entered in the third position will indicate one of the
following levels of maintenance:
Code
Application/Explanation
F - Support item is removed, replaced, used at the direct support level.
H - Support item is removed, replaced, used at the general support level.
(b) The maintenance coded entered in the fourth position indicates whether the item is to be repaired and
identifies the lowest maintenance level with the capability to perform complete repair (i.e., all authorized maintenance
functions). This position will contain one of the following maintenance codes:
Code
Application/Explanation.
F - The lowest maintenance level capable of complete repair of the support item is the direct support
1
