TM 5-1730-245-14
e. The "NOT FULLY MISSION CAPABLE IF:" column is the column of Table 4-2 in which entries will be
keyed specifically to checks listed in the "procedures" column for the purpose of identifying, for the check, the
criteria that will cause the equipment to be classified as not ready/available because of inability to perform its
primary Combat Mission. An entry in this column will:
a. Identify conditions that make the equipment not fully mission capable for readiness reporting.
b. Deny use of the equipment until corrective maintenance has been performed
4.12 PMCS Table. The necessary preventive maintenance services to be performed are listed and described
in Table 4-2. Defects discovered during operation of the system should be corrected as soon as possible. All
deficiencies and shortcomings will be recorded, together with the corrective action taken, on DA Form 2404
(Equipment Inspection and Maintenance Worksheet) as soon as possible.
TABLE 4-2. Unit Preventive Maintenance Checks and Services.
ITEM
INTERVAL
LOCATION
PROCEDURE
NOT FULLY MISSION
NO.
ITEM TO
CAPABLE IF:
CHECK/SERVICE
1
125 hours
Engine Oil and
Drain and refill. Refer to
Oil dirty.
Filter
2
125 hours
Hydraulic Fluid
Replace whenever fluid is
Clogged filter Is permitting
Filter
drained or after component/tool
dirty fluid to bypass.
failure Refer to paragraph 4.3.
3
125 hours
Air Cleaner
Clean element with
Element clogged.
compressed air.
4
250 hours
Air Cleaner
Replace element..
Element clogged.
5
500 hours
Fuel Filter
Replace element Refer to
Element clogged.
6
500 hours
Engine
Inspect for deterioration.
Deteriorated rubber.
Shockmounts
Report to Direct Support
Maintenance.
7
2000 hours
Fan Belt
Replace.
NOTE
Tension on a new radiator fan belt should be checked after installation and after
the first 25 hours of operation Refer to paragraph 4.21.
4-9
