ARMY TM 5-6115-633-14&P
(a) Position switch (6) on inside of cover (4). Insert four screws (13) with one flat washer
(14) and one preformed packing (15) each through cover and switch standoffs.
Install nut (14) so that flat side mates with washer (15).
(b) Install one flat washer (15) and one nut (14) on end of each screw (13) and tighten.
(c) Position knob (12) on switch (6) and install screw (10) and Iockwasher (11).
Observe identification bands on wires when reconnecting wires,
(g) Position cover (4)
on switch box (5) and secure with
16 screws (1),
(2) and 16 flat washers (3).
b. Power Cable and Wiring Repair. The switch box wiring is repaired by tightening or replacing
loose or damaged terminals. The power cables are repaired by replacing damaged terminals. The
repair parts and special tools list in this manual lists part numbers for the terminals. The replacement
terminals are soldered onto the wires in accordance with procedures given in TB SIG 222 (TO 31-3-
64) and TM 55-1500-323-25 (TO 1-1A-14).