TM 55-4920-438-13&P
3-20. Fixed Equipment/Components - Removal/Installation
3-20
This task covers: Removal/installation of fixed, equipment/components
INITIAL SETUP
Tools:
Personnel Required:
Tool Kit, Power Train, NSN 5180-00-003-5267
68D Aircraft Power Train Repairer
REMOVAL/INSTALLATION
NOTE
Permanently installed equipment or components should not be removed, however, in the event it
becomes necessary to remove, reinstall or replace fixed equipment or shop components within
the shelter care must be taken to remove all bolts, nuts and other fasteners. All cabinets and
racks are bolted to the floor and unless isolated, are normally bolted to adjacent cabinets and/or
to the wall and ceilings.
1. Remove bolts (1) nuts and washers (2).
2. During reinstallation of fixed equipment or components
the same hardware should be used so as to maintain the
original integrity of the shop sets. This is especially critical
in regard to items bolted to walls or ceilings.
END OF TASK
3-30
