TM 11-6130-243-35
GENERAL SUPPORT TESTING PROCEDURES
form each step in sequence. Do not vary the
sequence. For each step, perform all the
a. Testing procedures are prepared for use
actions required in the control settings
by field maintenance shops and service organi-
columns; then perform each specific test pro-
zations responsible for general support main-
cedure and verify it against its performance
tenance of electronic equipment to determine
standard.
the acceptability of repaired equipment. These
procedures set forth specific requirements that
3-2. Test Equipment, Tools, and Materials
repaired equipment must meet before it is re-
All test equipment, tools, and materials re-
turned to the using organization. These pro-
quired to perform the testing procedures
cedures may also be used as a guide for test-
given in this chapter are listed in a, b, and c,
ing equipment that has been repaired at direct
support, if the proper tools and test equip-
below and are authorized under TA 11-17,
ments are available. A summary of the per-
Signal Field Maintenance Shops; and TA
11-100(11-17), Allowances of Signal Corps
Expendable Supplies for Signal Field Mainte-
b. Comply with the instructions preceding
nance Shops, (Continental United States).
each chart before proceeding to the chart. Per-
a. Test Equipment.
c. Materials.
b. Tools. All the tools required are in-
cluded in Tool Kit, Electronic Equipment TK-
100/G and Tool Kit, Electronic Equipment
TK-105/G.