TM 11-6130-266-15
APPENDIX C
ORGANIZATIONAL, DIRECT SUPPORT, GENERAL SUPPORT,
AND DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL
TOOLS LIST
Section I. INTRODUCTION
C-1. Scope
C-3. Explanation of Columns
This appendix lists repair parts required for the
The following provides an explanation of columns in the
performance of organizational, direct support, general
tabular lists:
support, and depot maintenance of the PP-6224/U.
a. Source, Maintenance, and Recoverability Codes
(SMR).
NOTE
(1) Source code indicates the selec tion status
No special tools, test, and support
and source for the listed item. Source codes are:
equipment are required.
Code
Explanation
C-2. General
This Repair Parts List is divided into the following
P
Repair parts which are stocked in or supplied from
sections:
the GSA/DSA, or Army supply system and
authorized for use at indicated maintenance
a. Prescribed Load Allowance (PLA) -Section II. A
categories.
composite listing of repair parts having quantitative
P2 Repair parts which are procured and stocked for
allowances for initial stockage at the organizational level.
insurance purposes because the combat or
military essentiality of the end item dictates that
b. Repair Parts for Organizational Maintenance -
a minimum quantity be available .in the supply
system.
performance of maintenance at the organizational level.
P9 Assigned to items which are NSA design
controlled: unique repair parts, special tools,
c. Repair Parts for Direct Support, General
test, measuring and diagnostic equipment,
Support, and Depot Maintenance-Section IV. A list of
which are stocked and supplied by the Army
repair parts authorized for the performance of
COMSEC logistic system, and which are not
maintenance at the direct support, general support, and
subject to the provisions of AR 380-41.
depot level.
P10 Assigned to items which are NSA design
controlled: special tools, test, measuring and
d. Index-Federal Stock Number or Reference
diagnostic equipment for COMSEC support,
Number Cross-Reference to Figure and Item Number or
which are accountable under the provisions of
Reference Designation-Section V. A list of Federal stock
AR 380-41, and which are stocked and
numbers in ascending numerical sequence (section V.1)
supplied by the Army COMSEC logistic system.
followed by a list of reference numbers appearing in
M Repair parts which are not procured or stocked,
ascending alphanumeric sequence (section V.2) cross-
but are to be manufactured in indicated
referenced to the illustration figure number and
maintenance levels.
reference designation.
A
Assemblies which are not procured or stocked as
such, but are made up of two or more units.
e. Index-Reference Designation Cross-Reference
Such component units carry individual stock
numbers and descriptions, are procured and
designations cross-referenced to page numbers.
stocked separately and can be assembled to
form the required assembly at indicated
maintenance categories.
C-1
