TM 11-6130-266-15
d. Column 4, Maintenance Category. Column 4
specifies, by the listing of a "worktime" figure in the
B-4. Tool and Test Equipment Requirements (sec III)
appropriate subcolumn(s), the lowest level of
maintenance authorized to perform the function listed in
a. Tool or Test Equipment Reference Code. The
column 3. This figure represents the active time
numbers in this column coincide with the numbers used
required to perform that maintenance function at the
in the tools and equipment column of the MAC. The
indicated category of maintenance. If the number or
numbers indicate the applicable tool or test equipment
complexity of the tasks within the listed maintenance
for the maintenance functions.
function vary at different maintenance categories,
appropriate "worktime" figures will be shown for each
b. Maintenance Category. The codes in this
category. The number of task-hours specified by the
column indicate the maintenance category allocated the
"worktime" figure represents the average time required
tool or test equipment.
to restore an item (assembly, subassembly, component,
module, end item or system) to a serviceable condition
c. Nomenclature. This column lists the noun name
under typical field operating conditions. This time
and nomenclature of the tools and test equipment
includes preparation time, troubleshooting time, and
required to perform the maintenance functions.
quality assurance/quality control time in addition to the
time required to perform the specific tasks identified for
d. National/NATO Stock Number. This column lists
the maintenance functions authorized in the
the National/NATO stock number of the specific tool or
maintenance allocation chart. Subcolumns of column 4
test equipment.
are as follows:
e. Tool Number. This column lists the
C-Operator/Crew
manufacturer's part number of the tool followed by the
O-Organizational
Federal Supply Code for manufacturers (5 digit) in
F-Direct Support
parentheses.
H-General Support
D-Depot
B-5. Remarks (sec IV)
e. Column 5, Tools and Equipment. Column 5
a. Reference Code. This code refers to the
specifies by code, those common tool sets (not
appropriate item in section II, column 6.
individual tools) and special tools, test, and support
equipment required to perform the designated function.
b. Remarks. This column provides the required
f. Column 6, Remarks. Column 6 contains an
explanatory information necessary to clarify items
alphabetic code which leads to the remark in section IV,
appearing in section II.
Remarks, which is pertinent to the item opposite the
particular code.
(Next printed page is B-3.)
B-2 Change 3
