TM 5-1730-245-14
SECTION I. OPERATOR LUBRICATION INSTRUCTIONS
3.1
OPERATOR LUBRICATION INSTRUCTIONS .
There are no lubrications specific to operator
maintenance.
SECTION II. OPERATOR TROUBLESHOOTING
3.2 INTRODUCTION. This section provides information useful in the diagnosis and correction of problems or
failures that may be encountered in the operation of the hydraulic power supply. Troubleshooting is performed
whenever the hydraulic power supply is not functioning properly. Failures and malfunctions may often be
traced to relatively simple causes. Table 3-1 is a trouble analysis chart for the operator of the power unit. The
chart contains a listing of the troubles that might be encountered, the probable cause of the trouble and action
that may be taken to correct the condition. When using the troubleshooting chart refer to the operating
procedures in Chapter 2.
3.3 TROUBLESHOOTING CHART.
3.3.1 Table 3-1 lists common malfunctions that you may find with the hydraulic power supply. Perform the
tests, inspections and corrective actions In the order they appear in the table.
3 3.2 This table cannot list all the malfunctions that may occur, all the tests and inspections needed to find the
fault, or all the corrective actions needed to correct the fault. If the equipment malfunction is not listed or
actions listed do not correct the fault, notify your supervisor.
TABLE 3-1. OPERATOR TROUBLESHOOTING.
2.6.
2-1.
3-2
