TM 5-1730-245-14
4.24 FUEL CONTROL SOLENOID - REPLACE.
THIS TASK CONSISTS OF: a. Removal
b.
Installation
INITIAL SETUP
Tools:
Equipment Condition:
Shop Equipment Automotive Maintenance and Repair: Battery disconnected. See paragraph 4.19.
Organizational Maintenance, Common No 1, less power
1) Tag wires (1), remove the two screws (2) and remove wires (1) from the fuel control solenoid (3).
2) Remove the cotter pin (9), washer (8) from the push/pull rod (7) and withdraw the push/pull rod (7)
from the fuel control solenoid (3).
3) Remove the top bolt and nut (5) holding the fuel control solenoid (3) and the black solenoid ground
wire (4) to the backplate (10).
4) Remove the bottom bolt and nut (6) and remove the fuel control solenoid (3) from the backplate (10).
1) Install the fuel control solenoid (3) and secure to backplate (10) with bottom bolt and nut (6).
2) Install black solenoid ground wire (4) and secure to backplate (10) with top bolt and nut (5). Torque
top bolt (5) to 5 ft. lb. (7 0 Nm).
3) Install push/pull rod (7), washers (8) on to fuel control solenoid (3) and secure with cotter pin (9).
4) Install wires (1) on to fuel control solenoid (3) and secure with screws (2).
Figure 4-15. Fuel Control Solenoid.
4-31