TM 65-1790-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(2) With air flowing through fuel noz-
zle, lightly brush carbon deposits from nozzle
( 1 ) Position fuel nozzle with nozzle
with a brass brush.
pointing downward, and apply low pressure
air (approximately 30 psig) to inlet fitting.
c.
(See figure 6-2.)
(1) Install gasket (5), fuel nozzle (4),
and three bolts (3). Tighten bolts to 50 inch-
pounds and lockwire.
Do not use steel brush to clean face
(2) Reconnect fuel line (1) to fuel noz-
of fuel nozzle. Alteration of fuel spray
zle (4).
pattern may result.
Change 1
6-4.2
