TM 5-1730-245-14
4.26 STARTER - REPLACE.
THIS TASK CONSISTS OF: a. Removal
b.
Installation
INITIAL SETUP
Tools:
Equipment Condition:
Toolkit, General Mechanics (item 5, Section III, Appendix B).
Shop Equipment Automotive Maintenance and Repair:
Organizational Maintenance, Common No. 1, less power
1) Remove nuts (14) and lockwashers (13). Discard lockwashers.
2) Remove screw (5) and lockwasher (6). Tag and remove starter switch wire (4) from starter solenoid
(8).
3) Tag and remove fuel solenoid wire (12) from starter solenoid (8).
4) Tag and remove positive battery cable (3) slave receptacle cable (1) and harness wire (2) from starter
solenoid (8).
5) Support starter (11) and remove screws (9) and flatwashers (10) Remove starter (11).
1) Install the starter (11) using flatwashers (10) mounting bolts (9) and secure to 30 0 ft. lb. (41.0 Nm).
2) Install the wires (1), (2), and (3) and (12) to the starter solenoid. Install lockwashers (13) and nuts (14)
to the starter solenoid and secure to 4.5/8.5 ft lb (5.89/11 77 Nm).
3) Install wire (4) lockwasher (6) and screw (5) to the starter solenoid (8).
Figure 4-17. Starter.
4-33