TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
x. Remove main control manifold (15,
(2) Remove tube assembly (6), with
assembled swivel nut tee (49), from mod-
ule.
(1) Tilt module (about 30 degrees)
to the right to gain access to the holes
underneath - block module for support
aa. Remove tube assembly (17) as
follows:
and to prevent slippage.
(1) Remove upper connector of tube
(2) Remove six socket head cap
assembly (17) from bottom of tee (18) on
screws (67) that hold main control mani-
front of low pressure filter head assem-
fold (15) to module frame (1).
bly (22, figure 8-14). Remove and dis-
card copper seal.
(3) Remove supports and restore
module to normal position.
(2) Remove lower connector of tube
fold (51).
Remove and discard copper
Manifold weighs approximately 25
seal.
to 30 pounds. Take care to pre-
vent injury to personnel or damage
(3) Withdraw tube assembly (17,
to manifold.
(4) Slide manifold (15) out of the
ab. Remove tube assemblies (26 and
module's left side.
as follows:
Remove tube assembly (19, figure
(1) Remove lower connector of tube
assembly (51) from elbow (70, figure
(1) Remove lower connector of tube
8-14) on
end of
accumulator (16). Re-
assembly (19) from fitting (68, figure
move and discard copper seal.
8-14) on back of reservoir select mani-
fold (58).
Remove and discard copper
(2) Remove lower connector of tube
seal.
(28) on back of high pressure filter
(2) Remove upper connector of tube
and discard copper seal.
(22) on rear of low pressure filter head
ac. Remove accumulator (16, figure
discard copper seal.
(3) Withdraw tube assembly (19,
(1) Match mark accumulator (16) to
u-bolt (71).
z. Remove tube assembly (6, figure
(2) Remove four nuts (72) and
washers (73) to release u-bolts (71).
(1) Remove lower connector of tube
(3) Withdraw accumulator (16), two
u-bolts (71) and two cradle brackets
assembly (6) from check valve (50). Re-
move and discard the copper seal.
(74) from module.
8-34