TM
55-1730-229-12
AG
320A0-OMM-000
TO
35C2-3-473-1
TM
1730-12/1
Table 4-2.
Organizational Troubleshooting (continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(continued)
83.
NOTE
Two teat wires made from 20 gage wire are required for step e.
Each lead should be terminated on one end with a female connec-
tor pin, and with a clip on other end.
e.
Connect one teat wire between pin A of connector J8 and
positive terminal screw on back of slave receptacle. Connect
other test wire between pin B of J8 and negative terminal
screw of slave receptacle.
f.
Connect battery.
Do tests indicated in table 4-6 for relay in activated state.
g.
h.
Disconnect battery.
i.
Disconnect test wires.
If all indications in table 4-6 were normal, relay is good.
j.
Reconnect harness connector P8 to tray connector J8.
If any indication in table 4-6 was not normal, remove relay
k.
from socket (paragraph 4-36.b). Check for continuity between
the following points (see FO-3 sheet 2, FO-5, and FO-9):
Check continuity
If no continuity,
From
To
replace wire no.
J8-A
El7B20
socket
Xl
3K1
J8-B
socket
X2
E35B20N
3K1
J8-G
socket
Cl
P4B20
3K1
J8-E
socket
Bl
P5B20
3K1
P6B20
J8-C
socket
Al
3K1
J8-H
socket
C2
P13B20
3K1
P12B20
J8-F
socket
B2
3K1
J8-D
socket
A2
P11B20
3K1
P33B20
J8-J
socket
Dl
3K1
J8-K
socket
D2
P34B20
3K1
4-114
