TM 55-1730-229-12
AC 32OAO-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
(a) Open control panel access
(2) Tag and disconnect wires (13)
door (1) to reach control panel lamps
from switch terminals by removing two
screws (11) and washers (12).
(2).
(3) Remove two screws (4), washers
(b) Open hydraulic filters ac-
cess door (40) to reach hydraulic util-
(5), washers (3), lock washers (2), and
ity lamp (41).
nuts (1) and remove switch (6) from
mounting bracket (7).
(c) Open engine access door (42)
Install. (See figure 4-32.)
to reach engine utility lamp (47).
c.
(1). Attach switch to mounting
(d) Remove cable from storage
bracket (7) with two screws (4), washers
compartment (48) and remove fuel access
cover (49) to reach fuel utility lamp
(5), washers (3), lockwashers (2), and
nuts (1).
(50).
(2) Center switch vertically on
(3) See figure 4-33. Remove lamp
bracket (7) and tighten nuts (1).
(1) from socket (4) by pressing in on
lamp and turning counterclockwise.
(3) Connect wires (13) to switch
terminals using two screws (11) and
b. Install. Place lamp (1) in
washers (12).
socket (4). Press lamp and turn clock-
wise to lock in place.
Replace access
(4) Open bypass door (9) and check
panel or close access door.
that switch actuates (indicated by
click) when door is open (at bottom)
between 1/4 and 1/2 inch. If necessary,
ad just switch position.
To adjust,
loosen nuts (1), slide switch (6) up or
down on bracket (7), and tighten nuts.
Remove all rings, watches and other
Move switch down if switch actuation oc-
jewelry when performing maintenance
curs when bypass door opening is less
on this equipment.
than 1/4 inch. Move switch up if actu-
NOTE
ation occurs when bypass door opening is
greater than 1/2 inch.
See table 4-2, Malfunctions 11
(step 13) and 12 (step 11) for
test.
a. Remove. (See figure 4-33.)
Remove all rings, watches and other
(1)
Remove
lamp
4-45 .a).
jewelry when performing maintenance
on this equipment.
(2) Remove screw (2), washer (3)
NOTE
and socket (4).
(3) Remove heat shrink insulator
See table 4-2, Malfunctions 11
from wires connected to lamp socket.
(Step 12) and 12 (step 10) for
Unsolder wires from solder lugs (5).
test.
b. Install. (See figure 4-33.)
a. Remove.
(1) Install heat shrink insulator
(1) Disconnect battery.
on wires and solder wires to solder lugs
(2) See figure 4-12 and:
(5). Use heat gun to shrink insulator.
