TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(g) Install eight capscrews (9,
13) and washers (10, 14), but do not
tighten at this time.
Do not put hands or fingers under
rear of generator while lifting
(h) Install two capscrews (2)
engine. Generator end may tip
down when lifted.
port and tighten.
(f) Carefully lift engine from
(i) Install four capscrews (6)
mounts while guiding engine/generator.
and washers (7) in left mounting block
Remove pins (16, 17) from engine mount-
(11) and tighten.
ing pads.
(j) Tighten capscrews (9, 13)
installed In step (g).
(g) Move engine forward a few
inches to clear housing and lift engine
from AGPU.
(k) If required, loosen two nuts
(20) and turn adjuster (21) to level en-
Ensure that LCV adapter aligns
gine.
(h) Install engine in mainte-
Tighten
nance stand.
with pneumatic hose fitting.
nuts (20).
(i) Check AGPU floor around
engine
Remove all signs of
(1) Lockwire capscrews (2, 6, 9,
Touchup paint as
and 13).
corrosion or rust.
required.
Installation.
b.
(2) Connect starter ground cable
(1) Install
engine/generator/hy-
(3) Connector generator electrical
connections.
to engine lifting cable (3), and lifting
(a) Connect ground lug wire (29,
strap (1) wrapped around generator.
nut (28).
(b) Carefully lift engine from
(b) Ensure that jumper (19)
maintenance stand and position over
AGPU.
(c) Carefully lower engine to a
(c) Install six AC cables (23)
position just above engine mounts.
on AC terminal block (18) studs. Secure
(d) Install pins (16, 17, figure
(21), and nuts (20).
2-11) in
engine mounting pads.
(d) Install cover (30) on AC
terminal block (18) with two screws (24)
(e) Carefully lower engine until
and washers (25).
pins are seated in mounts (18, 19), and
(e) Install DC cable (16) on DC
terminal block (7) with washer (15),
(f) Install mounting blocks (11,
lockwasher (14), and nut (13).
15).
2-47