TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
d. Install.
Install reservoir by
(e) Install gauge in reservoir
p e r f o r m i n g steps o. through aj. and as.
(21) using nut (25), and nut (22) and
spacer (23).
8-9.
FILTER HEADS.
(7) Replace tube assemblies (28)
a . Remove. Remove filter heads (6
a s follows:
( a ) Loosen nut of tube assembly
(28) and remove tube assembly.
Inspect.
b.
(b) Install tube assembly (28).
E n s u r e that end of left tube assembly is
(1) Inspect internal threads on
f i l t e r h e a d ( 6 , 15) body for damage.
a l i g n e d with center of baffle (29).
R e p l a c e filter head if damaged.
(8) Replace fittings (32) as fol-
lows :
(2) Inspect coupling ends of fit-
tings (7, 11) for scratches or gouges.
Replace if damaged.
( a ) Remove tube assembly (28).
(3) Inspect coupling ends of el-
(b) Remove four bolts (30) and
bow (2) and tee (17) for scratches or
nuts (31).
gouges.
Replace if damaged.
( c ) Remove fitting (32) and gas-
k e t ( 3 3 ) . Discard gasket.
(4) Inspect wires (21) to switch
Repair by
b o d y for damaged insulation.
splicing if damaged.
(d) Coat threads of Four bolts
( 3 0 ) with RTV 106.
(5) Inspect adapters (4, 9, 13 and
1 9 ) for worn threads.
(e) position fitting (32) with
new gasket (33) and install four bolts
(30) and nuts (31).
( 1 ) R e p l a c e e l b o w (2) and adapter
(f) Install tube assembly (28).
(4).
E n s u r e that end of left tube assembly is
a l i g n e d with center of baffle (29).
(a) Match mark elbow (2) and
filter head (6).
Loosen nut (1) and
(9)
Replace
fitting
(34)
as
fol-
lows :
remove elbow (2) a n d p a c k i n g ( 3 ) . D i s -
card packing.
Remove four bolts (30) and
(a)
nuts (31).
( b ) Remove adapter (4) and pack-
Discard
ing (5) from filter head (6).
R e m o v e fitting (34) and gas-
packing.
(b)
k e t ( 3 5 ) . Discard Rasket.
(c) Install adapter (4) with new
p a c k i n g (5) .
Coat threads of four bolts
(c)
(30) with RTV 106.
(d) Back off nut (1) as far as
(d) Position fitting (34) with
install elbow (2) with new
possible,
new gasket (35) and install four bolts
p a c k i n g ( 3 ) , align to match marks, and
(30) and nuts (31).
t i g h t e n elbow in position with nut (1).
8-14