TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
Electrical Assemblies Inspection/Check Procedures (continued)
Table 9-1.
Item
Requirements
No.
Inspect/Check
Nomenclature
No cracks allowed.
Visually check brackets on
Ignition Unit
7
ignition unit for cracks.
(continued)
No corrosion allowed. No
Visually check electrical
damage to pins allowed.
connectors for corrosion and
bent, broken and burned pins.
Visually check electrical
No stripped, galled or worn
threads allowed.
connectors for stripped,
galled and worn threads.
Speed sensor
Visually check case for
No dents or cracks allowed.
23
dents and cracks.
Visually check connector for
No bent, broken or burned
bent, broken and burned pins.
pins allowed.
Visually check mounting
No cracks in mounting
flange for cracks and dis-
flange or distorted bolt
hole allowed.
tored bolt hole.
Using multimeter check
Resistance shall be 20 ohms
resistance between pins
maximum.
A and C.
Using a Kelvin Bridge check
Resistance shall be 0.010
resistance between case and
ohm maximum.
pin B.
(4) Disconnect electrical connec-
(6) Loosen clamp (12), then remove
tor (9) from load control valve (11).
adapter (13) and clamp (12) from engine.
(5) Loosen clamp (10), then remove
load control valve (11) and clamp (10)
b. Inspection and Checks. Perform
from adapter (13).
procedures contained in table 9-2.
9-9
