TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
LEGEND FOR FIGURE 10-11:
c. Cleaning.
as rust-preventive compound or protec-
tive grease.
d.
Inspectlon and Repair.
Cleaning solvent P-D-680 is flam-
mable and should not be used near
(1) Inspect the 20-tooth and 81-
an open flame. Fire extinguishers
The
tooth gears for physical damage.
should be provided when these ma-
gear teeth should be free of chips,
terials are in use. In addition,
Minor flaws
burrs, and broken teeth.
these materials evaporate quickly
may be removed with a fine file and
Major defects will require
stone.
and have a drying effect on the
skin. If used without gloves,
Check the gears for
gear replacement.
cracks. Lay the 81-tooth gear on a flat
they may cause cracks in the skin
and irritation or inflammation.
surface and check for twists or distor-
Use only in well ventilated
tion.
Check the inside of the driven
places. The use of diesel fuel
sleeve mounting hole. The inside sur-
oil, gasoline, or benzine (benzol)
face should be clean and smooth. Minor
for cleaning is strictly prohib-
flaws may be removed with fine emery
ited.
Check the 20-tooth gear keyway
paper.
for cracks, chips, or burrs.
Minor
(1) Use solvent P-D-680 to clean
flaws may be repaired with a fine file
or wash grease and oil from all parts of
and stone.
Remove any
the chain drive assembly.
traces of the housing gasket that re-
(2) Carefully inspect the chain
Lay the
mains on the housing or the adapter
for broken or damaged links.
plate.
chain on edge on a flat surface and
check for twists or distortion. Replace
the chain if damaged. All links should
(2) Before installing new parts,
remove any preservative materials such
move freely with no binding or catching.
10-17
