TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(6) Install rear axle
assembly
c. Install.
(1) Locate square key (9) in key-
(7) Apply power to the drive sys-
way of traction motor (1) driveshaft.
tem in the alternate propulsion mode
(2) Position driveshaft in elec-
(TM 55-1730-229-12). Functionally check
dead-man
electric brake by pressing
tric brake (8). If required, rotate
switch and listening for an audible
traction motor (1) to ensure electrical
click from electric brake.
connectors S1 and A2 are uppermost and
mounting holes align.
10-11.
ELECTRIC BRAKE.
a.
Removal.
(3) Tighten turnbuckles (7) evenly
using a socket wrench ensuring that
NOTE
there will be no damage to traction
motor (1) or electric brake (8).
In the following step it is not
necessary to remove the motor
(4) Locate motor support bracket
support bracket from the trac-
(5) on traction motor (1). Secure with
tion motor.
washers (11) and cap screws (10). safety
(1) Remove traction motor para-
wire cap screws using lockwire, part
number MS20995NC32.
(2) Remove three cap screws (1),
cap screw (2) and washers (3) securing
(5) Secure motor support bracket
electric brake (4) to worm gear reducer
(5) to motor mounting plate (6) with cap
gearbox (5). Remove electric brake (4).
screws (4), washers (3) and lock nuts
Remove and retain square drive key (6).
(2).
10-31
Change 2