TM 9-6115-652-14&P
Section
VIII. MAINTENANCE OF POWER UNIT TRAILER
4-16. G e n e r a l . This section of the manual contains unit level maintenance procedures for components of the
M200A1 trailer added when the trailer is used as part of the PU-760/M power unit. These components are not
covered in the overall trailer maintenance manual. For all other unit maintenance procedures on the trailer, refer
to TM 9-2330-205-14&P. When power unit has been painted in camouflage, replacement parts must be painted
to match authorized patterns and colors as specified in TB 43-0147. Application of camouflage paint shall be
done in accordance with MIL-C-53072.
Before performing any maintenance that requires climbing on or under trailer, set trailer
handbrakes, chock both wheels, and lower rear leveling jacks. Injury to personnel could
result from trailer suddenly rolling or tipping.
4 - 1 7 . F u e l C a n B r a c k e t R e p l a c e m e n t . (See figure 4-5.) There are two fuel can brackets supplied with
t h e PU-760/M. The brackets are mounted on top of the curbside front step. Replacement procedures described
below are the same for both.
Figure 4-5. Fuel Can Bracket Replacement.
a. R e m o v a l .
(1) Remove four screws (1, figure 4-5), four self-locking nuts (2) and four flat washers (3) securing bracket
(4) to step (5).
( 2 ) Remove bracket (4) from step (5).
4-13
