TM 11-5820-765-34
Section
III.
MAINTENANCE
PROCEDURES
Shut off power supply before performing maintenance.
Capacitors carry a charge after power supply is shut off.
Short out capacitors with shorting rod.
Be careful during removal and replacement.
You can prevent accidental damage to other parts, and you can prevent
potential
short
circuits
caused
by
dropped
hardware.
When removing and replacing a part, check carefully for loose hardware or
insecure
electrical
connections.
Do not operate equipment until you make these checks.
NOTE
No special tools or procedures are needed to remove and replace power
supply
parts.
2 - 1 0 . REMOVING AND REPLACING PANELS.
The power supply's front, top, and rear panels can be removed to allow maintenance inside the
unit.
To replace top panel, connect fan plug and replace 15 screws, washers, nuts.
