TM 32-5811-018-14&P
(11) Cooling fan B1 removal.
(a) Remove intake filter (16) from chassis in accordance with
(b) Loosen four screws (20), lock washers (21), flat washers
(22), and rim clinch clamps (23) that secure fan spacer
(15) to fan (14). Turn the clamps so that flat side is
toward the fan and remove fan (14).
(12) Support plate removal. To remove the support plate, remove
bottom cover (3) in accordance with paragraph 6-8a(1), then
remove three screws (24) that secure support plate (25) to
chassis (4) and remove the plate from the chassis.
(13) Exhaust filter removal.
(a) Remove bottom cover (3) in accordance with paragraph
6-8a(1) .
(b) Remove ten screws (26) that secure exhaust filter (27) to
side of chassis (4) and remove exhaust filter.
(14) Time meter M1 removal.
(a) Remove top cover (2) in accordance with paragraph 6-8a(1).
(b) Pull heatshrink tubing away from connector terminals, tag,
and unsolder wires from meter (33).
(c) Remove two screws (29), lock washers (30), flat washers
(31), and nuts (32) that secure time meter (33) to chassis
(4) and remove time meter.
(15) Anqle bracket removal.
(a) Remove front panel in accordance with paragraph 6-8a(19),
step (a), (b) and (c).
(b) Remove four nuts (43), lock washers (44), and flat washers
(45) that secure brackets (46) to screw inserts on rear of
panel (9) and remove angle brackets.
(16) Connector removal. The number of connectors varies with
each power supply, but the removal procedure is the same.
(a) Remove top and bottom covers in accordance with paragraph
6-8a(1).
(b) Remove holddown hooks (8) in accordance with paragraph
6-8a(6).
(c) Remove eight screws (9A) that secure front panel (9) to
chassis (4) and two screws (9E) that secure front panel to
heatsink (12). Remove panel from chassis.
(d) Remove four screws (34) , flat washers (35), lock washers
(36), and nuts (37) that secure connector (38) to front
panel. Also remove terminal lug (59).
(e) Tag each wire, then use a removal tool to remove each wire
from connector. Remove connector from front panel (9).
(17) Handle removal.
(a) Remove top and bottom covers in accordance with paragraph
6-8a(1).
(b) Remove holddown hooks (8) in accordance with paragraph
6-8a(6).
6-14
