TM 32-5811-018-14&P
(d)
Replace top and bottom (2 and 3) covers in accordance
with paragraph 6-8b(1).
Identification plate replacement. Secure identification
(18)
plate (50) on front panel (9) with two screws (47), lock
washers (48), and flat washers (49).
Front panel replacement.
(19)
Secure identification plate in accordance with paragraph
(a)
6-8b(18).
(b)
Secure angle brackets (46) to studs on rear of front
panel (9) with four nuts (43), lock washers (44), and
flat washers (45).
(c)
Install RE' contact strip (item 6, App. D) to the chassis
front panel opening with pressure sensitive tape (item 18,
(d)
Secure handles (42) on front panel (9) with two screws
(41).
Replace connectors J1 through J7 in accordance with para-
(e)
graph 6-8b(16).
(f)
Replace holddown hooks in accordance with paragraph
6-8b(6) .
Secure front panel to heatsink (12) with two screws (9E).
(g)
Also secure front panel to chassis with eight screws
(9A).
Replace top and bottom covers (2 and 3) in accordance
(h)
with paragraph 6-8b(1).
Terminal board replacement.
(20)
Secure terminal board (51) to plate (52) with two screws
(a)
(56), lock washers (57) , flat washers (58) and nuts (60) .
Solder wires, as marked, to terminals of terminal board
(b)
(51) and remove tags.
(c)
Secure plate (52) to heatsink (12) using five screws
(53), lock washers (54) and flat washers (55).
Install overvoltage protection modules U1, U2, U3 and U4
(d)
in accordance with paragraph 6-8b(8).
(e)
Install power supply modules PS1, PS2, PS3, and PS4 in
accordance with paragraph 6-8b(7).
(f)
Install top and bottom covers on chassis (4) in
accordance with paragraph 6-8b{1).
Riveting.
c.
To replace a rivet(s) on chassis or hardware item, proceed as
follows:
(1) Remove covers and components as required to gain access to
(Refer to Tool Lisitng in Appendix
rivet(s) to be replaced.
B.)
(2) Center punch the rivet head of rivet to be replaced.
( 3 ) Using a drill smaller than the diameter of the rivet, drill
out the center of rivet head to be replaced.
6-19
