TM 32-5811-018-14&P
Secure support plate (25) to
(12) Support plate replacement.
chassis (4) with three screws (24) , then replace bottom
cover (3) in accordance with paragraph 6-8b(1).
(13) Exhaust filter replacement.
(a) Install RF contact strip, (item 6, App. D), to the exhaust
filter with pressure sensitive tape, type 467 (item 18,
(b) Secure exhaust filter (27) to the side of the chassis with
ten screws (26).
Install bottom cover (3) on chassis (4) in accordance with
(c)
paragraph 6-8b(1).
(14) Time meter Ml replacement.
(a) Solder wires, as tagged, to terminals of time meter (33).
(b) Slide heatshrink tubing (item 12, App. D) over connec-
tions and remove tags.
(c) Secure time meter (33) to chassis (4) with two screws
(29), lock washers (30), flat washers (31), and nuts
(32).
(d) Install top cover (2) on chassis (4) in accordance with
paragraph 6-8b(1).
(15) Angle bracket replacement.
(a) Secure bracket (46) to studs on rear of front panel (9)
with four nuts (43) , lock washers (44) , and flat washers
(45).
(b) Replace front panel in accordance with paragraph 6-8b(19)
steps (f), (g), and (h).
(16) Connector replacement. The number of connectors varies
with the power supply, but the replacement procedure is the
same.
(a) Use insertion tool to insert wires into connector (38) as
marked during removal. Remove tags.
(b) Secure connector (38) to front panel (9) using four
screws (34), flat washers (35) , lock washers (36), and
nuts (37) with terminal lug (59).
(c) After ensuring the RF contact strip is intact, secure
front panel (9) to chassis with eight screws (9A) and
secure to heatsink with two screws (9E).
(d) Replace holddown hooks (8) in accordance with paragraph
6-8b(6).
(e) Replace top and bottom covers (2 and 3) in accordance
with paragraph 6-8b(1).
(17) Handle replacement.
(a) Secure handle (42) on front panel (9) with two screws
(41).
(b) After ensuring the RF contact strip is intact, secure
front panel to chassis with eight screws (9A) and secure
to heatsink with two screws (9E).
(c) Replace holddown hooks (8) in accordance with paragraph
6-8b(6).
6-18
