TM
55-1730-229-12
AG
320A0-OMM-000
TO
35C2-3-473-l
TM
1730-12/1
c. Set hydraulic control panel OUTPUT switch to
OFF and check that output light goes out.
Maximum towing speed on improved
d. Hold hydraulic control panel PRESSURE switch
surfaces is 20 mph. Maximum offroad
to DECREASE position to reduce hydraulic pressure to
speed is 10 mph. Maximum turn angle is
approximately 500 psig.
20. Do not make sharp turns forward or
back while towing.
e. Open hydraulic control panel HIGH PRESSURE
BYPASS valve.
f. Set hydraulic control panel POWER switch to
Battery must be connected prior to moving
OFF and check that POWER ON light goes out.
AGPU. This will ensure the No Tow
Warning system will be activated Failure
2-13. AGPU SHUTDOWN.
to connect the battery could result in
severe damage to the AGPU drive unit.
Engine Shutdown.
a.
a To tow the AGPU, release the tow bar latch and
(1) Set control panel ENGINE CONTROL
lower the tow bar to the towing position.
switch to STOP.
(2) Check that control panel LOW FUEL
PRESSURE, LOW OIL PRESSURE, and BAT
Towing AGPU with clutch lever engaged
CHG/DISCH lights illuminate,
will damage drive mechanism.
(3) Set control panel MASTER switch to OFF,
b. Verify that the clutch lever is pushed in to
and leave battery connected.
disengage the drive mechanism, and quick-release
pin is installed.
b. Emergency Engine Shutdown.
c. Check that DO NOT TOW light is out.
NOTE
d. Engage the tow bar ring with the pintle on the
Engine shutdown can only be
towing vehicle.
accomplished by removing fuel source.
If shutdown fuel solenoid or associated
e. Release the AGPU parking brake.
control circuit should fail, engine shutdown
can he accomplished by setting control
f. Ensure that all doors are closed and secure prior
panel MASTER SWITCH to OFF (this
to towing.
removes voltage from auxiliary fuel pump,
and stops fuel flow).
(1) Set control panel ENGINE CONTROL
a. Ensure that control panel DC POWER, AC
switch to STOP, or push red EMERGENCY STOP
POWER, and PNEUMATIC POWER switches are set
pushbutton switch on front of AGPU.
to OFF and check that associated indicator lights are
out.
b. Check that BATTERY OUTPUT switch is set to
OFF.
