TM
55-1730-229-12
AC
320A0-OMM-000
TO
35C2-3-473-l
TM
1730-12/l
(9) To secure the AGPU, perform the following
NOTE
steps:
Perform all trimpot adjustments in order
shown.
(a) Raise the tow bar to the vertical locked
position.
(a) VOLTS ADJUST. Adjust volts. Adjust
trimpot so motor whines but does not turn when twist
(b) Pull the brake lever down to a horizontal
position to set the rear brakes.
grips are first twisted forward.
(b) CURRENT LIMITER. Turn current
(c) Set the BATTERY and DRIVE switches to
limiter trimpot the full direction of the arrow.
the OFF position.
(c) ACCELERATOR. Turn accelerator
(d) Set MASTER SWITCH to OFF position.
trimpot the full direction of the arrow, and then
approximately 1/2 turn in the reverse direction.
(e) Remove the quick release pin and push in
the clutch lever at the rear of the AGPU to disengage
(d) MAX BRAKE. Turn max brake trimpot
the drive mechanism and reinstall the quick release pin.
the full direction of the arrow, and then in the reverse
direction approximately l/2 turn.
NOTE
(e) BRAKE. Turn brake trimpot full
Install roof IAW paragraph 4-16b.
OPPOSITE direction of the arrow to start. Turn up l/8
inch in the direction of the arrow. The objective of the
adjustment is to have a smooth start with enough brake
to stop the unit without a violent stop when reversing
directions. The unit should be able to stop and reverse
on an incline or level ground without violent
movement. Move unit forward and reverse and adjust
brake trimpot until the correct adjustment is made.
Change 6
