TM 55-1730-229-12
AG 320A0-OOM-000
TO 35C2-3-473-1
TM 1730-12/1
Organizational Troubleshooting (continued)
Table 4-2.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
(continued)
70.
b. Notify maintenance supervisor of any leaks that cannot be
corrected.
Step 2.
Visually inspect rigid tubing, connectors, valves, and other
hydraulic components.
a. Wipe away leakage to see if leakage persists.
b. Notify maintenance supervisor of leakage that cannot be
corrected.
DRIVE POWER ON INDICATOR DOES NOT LIGHT WHEN PROPULSION MODE OPERATION
71.
ATTEMPTED.
Step 1.
Check operating procedure (paragraph 2-10).
If DRIVE power on indicator lights during primary propulsion
a.
mode operation (paragraph 2-10.a) but not during alternate
mode (paragraph 2-10.b), go to step 6.
b.
If DRIVE indicator lights during alternate mode but not
during primary mode, go to step 4.
If DRIVE indicator does not light during primary or alternate
c.
mode, continue with step 2.
Test DRIVE switch (malfunction 79).
Step 2.
Replace switch if defective (paragraph 4-104.c), and perform
a.
operational check.
If switch tests good, do step 3.
b.
Check that battery is disconnected. Remove battery charger access
Step 3.
cover. Disconnect main harness connector P6 from control panel
connector J6. Check for continuity between the following points (see
