TM 55-1730-229-12
TO 35C2-3-473-1
12. NUT
20. CABLE P32A6
13. WASHER
21. 50 AMP OUTPUT J3 (+) TERMINAL
14. WIRE P21C20N
22. CABLE P21A6N
15. CABLE P21A6N
23. 50 AMP OUTPUT J3 (-) TERMINAL
24. NUT
16. CABLE P21B2N
17. 50 AMP INPUT J4 (-) TERMINAL
25. WASHER
18. CABLE P22A2
26. WIRE P21C20N
19. 50 AMP INPUT J4 (+) TERMINAL
27. CASE GROUND TERMINAL
Figure 4-17. Battery Charger (sheet 2 of 2).
(9)
Install harness connector P2 (6) on bat-
tery charger connector J2 (7). Turn locking collar (3)
FOR SHORTS.
clockwise.
a.
Electrical connectors P-1 and P-6 (battery
(10)
Install harness connector P1 (4) to bat-
charger voltage adjustments plug and in-line connector
tery charger connector J1 (5). Turn locking collar (3)
to the lower tray), located behind the main control panel,
clockwise.
should be removed from their mating connectors and
inspected for possible shield-wire shorts as described
(11)
Install cable clamp (2) around main har-
below:
ness cables (8). Attach clamp to charger with charger
cover screw (1).
(1)
Remove AGPU battery connector P-17 in
battery compartment.
(12)
Replace battery charger access cover.
(13)
Replace control panel and close control
panel access door.
