TM
55-1730-229-12
AG
32OAO-OMM-000
TO
35C2-3-473-1
TM
1730-12/1
NOTE
a. Inspect. (See figure 4-50.)
See table 4-2. Malfunction 98 for test.
Remove hydraulic access cover (refer to
(1)
a Inspect. (See figure 4-50.)
Inspect filter cover (2) for dents. cracks, a
(2)
Open engine access door (12. figure 1-1).
(1)
other damage. No dent or cracks are allowed.
Inspect fuel solenoid (8) for dents a cracks.
(2)
b.
Remove. (See figure 4-50.)
No dents cracks are allowed
Loosen bolts (1). and rotate filter cover to
(1)
Inspect for security of installation. Tighten
(3)
disengage. Remove filter cover (2) with packing (3) and
mounting bolts or fuel line connections if required.
filter assembly (4).
b. Remove. (See figure 4-50.)
Remove packing (3) and filter assembly (4)
(2)
from filter cover (2). Discard packing and filter assembly.
(1)
Disconnect fuel lines (9) and elecirical
connector (5) from fuel solenoid (8).
C.
Install. (See figure 4-50.)
Remove bolts (6). washers (7). and fuel
(2)
clean filter cover (2).
(1)
solenoid from bracket.
Insert filter assembly (4) into fuel control
(2)
unit (FCU).
Install filter cover (2) with packing (3) onto
(3)
FCU, and rotate to engage cover.
Tighten bolts.
When starting engine for first time after replace-
(4)
ment of fuel solenoid, be prepared to shutdown
Install hydraulic access cover (refer to para-
(5)
engine by setting control panel MASTER
graph 4-15).
SWITCH to OFF (to remove power from auxil-
iary pump) should engine overspeed occur or
engine fail to shutdown in normal manner.
Change 7
