TM
55-1730-329-12
AG
320A0-OMM-000
TO
35C2-3-473-1
TM
1730-12/1
(7) DELETED.
b. Install.
(See figures 4-52 and
4-53.)
(8) Connect low fuel level sensor
NOTE
(4) wiring. Remove tags.
Use RTV Red gasket maker (Permatex
(9) DELETED.
26B) when installing hoses (2, 10,
16, 18, 22, figure 4-53).
(10) Check for leaks after tank is
(1) Install hoses (2, 10, figure
filled.
4-52), screen strainer (3) and fuel
pipe (8). Secure with clamps (1, 7, 9).
AND FITTINGS.
(2) Install vent hoses (16, 18,
22), Y-vent tube (20) and fuel hose
a. Remove.
coupler (23). Secure with clamp
(See figures 4-52 and
(14,
4-53.)
15, 17, 19, 21). Secure loop cushion
screws (11) and
clamps (13),
lock
(1) Loosen clamps (1, 7 and 9,
washers (12).
screen strainer (3) and fuel pipe (8).
(3) Install flat washer (27) on
smaller end of fuel vent breather assem-
(2) Remove screws (11) and lock
bly (26).
Secure fuel vent breather
washers (12). Loosen clamps (14, 15, 17,
assembly to hose (28) using clamp (24).
19, 21) and remove vent hoses (16, 18,
22), Y-vent tube (20) and fuel hose
(4) Install hose (32) to far side
coupler (23).
of plenum. Ensure hose is fully extended
below AGPU. Secure to fuel vent breather
(3) Loosen clamps (24, 25) and
assembly (26) with clamp (25).
remove fuel vent breather assembly (26),
flat washer (27) and hose (28). Remove
(5) Install loop clamp (31) on
lock nut (29), screw (30) and clamp
hose (33) and secure to AGPU skirt with
(31) and remove hose (32).
screw (30) and lock nut (29).
(4) Remove tube assemblies (2)
(6) Install bulkhead unions (4,
unscrewing coupling nuts.
retaining nuts (3).
(5) Remove bulkhead unions (4) and
(7) Install tube assemblies (2)
elbow (7) by removing retaining nuts
and hose assembly (9). Torque coupling
nuts to 120 20 inch-pounds.
(3).
(b) Tag and electrically discon-
(8) Install pressure sensor (10)
nect wires to pressure sensor (10).
in fitting (11). Remove tags and elec-
Remove pressure sensor (10) by unscrew-
connect wires to
trically
pressure
ing from fitting (11).
sensor (10).
Change 2
