TM 55-1730-229-12
AG 320A0-OMM-000
TO 35C2-3-473-1
TM 1730-12/1
(4) Remove speed/direction control
(4) On tow bar (2) and tongue
assembly (paragraph 4-118).
(20) install bolts (11), and washers
(10) to secure spring loops (9).
(5) Raise tow bar assembly (2) to
vertical position to relieve tension
(5) Install washers (8), and lock
from springs (18).
nuts (7) on bolts (11).
(6) Remove two nuts (3), two
(6) Secure wire harness with
washers (4), two clamps (5), and two
clamps (5) to tow bar (2) with two
screws (6) securing wiring harness to
underside of tow bar assembly (2).
screws (6), two washers (4), and two
nuts (3).
(7) On tow bar (2) and tongue
(7) Install speed/direction con-
(20), remove lock nuts (7) and washers
trol assembly (paragraph 4-118).
(8) from bolts (11).
(8) Connect battery.
(8) Remove bolts (ll), and washers
(10) to release spring loops (9).
(9) Remove nut (12), washer (13),
and bolt (14) that lock shaft (19) in
place.
(See figures 4-86 and
a. Inspect.
(10) Remove two lock nuts (15), two
4-87.)
washers (16), two sleeves (17), and two
springs (18) from shaft (19).
(1) Inspect front and rear brake
cables (1 and 2, figure 4-86), and cable
(11) Support tow bar (2) and remove
fixture (4) for broken strands, missing
or loose fasteners or mounting hardware
shaft (19). Remove tow bar.
and improper operation.
(See figure 4-85.)
Install.
b.
(2) Inspect brake lever assembly
(1) Raise tow bar and install
(17, figure 4-87) for bent or broken
shaft (19) through holes in tow bar as-
components, loose or missing fasteners,
sembly (2), aligning with holes in
improper operation and corrosion.
Lock shaft in place with
tongue (20).
bolt (14), washer (13), and nut (12).
(3) Remove rear wheels and tires
(2) Place springs (18), sleeves
(17), washers (16) and lock nuts (15)
onto shaft (19).
(4) Inspect rear wheels brake as-
(3) Raise tow bar to vertical po-
sembly (see paragraph 4-115 for removal)
sition to remove tension from springs
for loose fasteners, broken components,
(18).
worn shoes and corrosion.
