TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
TROUBLESHOOTING
Section II.
INTRODUCTORY INFORMATION.
2-3.
help you to determine probable causes
You
and corrective actions to take.
should perform the tests/inspections and
a. This section contains trouble-
corrective actions in the order listed.
locating and correcting operating trou-
b. This manual cannot list all mal-
functions that may occur, nor all tests
bles which may develop in the AGPU hy-
or inspections and corrective actions.
draulic system and propulsion system.
Each malfunction for an individual com-
If a malfunction is not listed or cannot
be corrected by listed corrective ac-
ponent, unit, or system is followed by a
list of tests or inspections which will
tions, notify maintenance supervisor.
Table 2-2.
Direct/General Support Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
NOTE
FO numbers referenced in this table are contained in TM 55-1730-
229-12.
1. REPLACE FILTER LIGHT STAYS ON AFTER FILTER ELEMENTS REPLACED.
Step 1.
Set power switches off, shut down engine, and disconnect battery. Remove
hydraulic module front panel assembly. Disconnect both leads from TB2-4 (see FO-
9) and check continuity between TB3-1 and the loose ends of wire C117B16.
2-2
Change 1