TM 55-1730-229-34
TO 35C2-3-473-2
(6) Install new seals (19) in end
(6) Remove exhaust access cover
of hoses (3, 4). Connect hydraulic
(3, figure 2-4) by removing twelve
hoses (3, 4) to hydraulic module (5).
screws (1), and washers (2).
Tighten hose (3) coupling nut to 200 to
230 inch-pounds of torque. Tighten hose
(7) Slide ejector inlet tube (7,
(4) coupling nut to 900 to 1,000 inch-
pounds of torque.
(8) Remove twelve nuts (8) and
lockwashers (9) from studs (10).
(7) Connect hydraulic hose (6)
quick-disconnect (7) to hydraulic module
(5).
(8) Connect electrical connector
(P14) (21) at rear of hydraulic module.
Ensure that exhaust ejector clears
AGPU frame and insulation when re-
moving or installing. Insulation
(9) Position hydraulic module
front panel (2) and secure with ten
weld pins on exhaust ejector can
screws (l).
shred housing insulation.
Refer to
(10) Install AGPU roof.
(9) Attach a rope or sling to lift
TM 55-1730-229-12, paragraph 4-16.
points (14). Remove exhaust ejector by
carefully lifting straight up.
(11) Service hydraulic module as
described in TM 55-1730-229-12.
Installation. (See figure 2-2.)
b.
battery cable to
(12) Reconnect
installation
area.
battery.
(1) Inspect
Remove all signs of corrosion or rust.
2-9. REMOVAL AND
INSTALLATION OF EX-
Touchup paint if required.
HAUST EJECTOR.
(2) Inspect two silicone rubber
Replace if torn. Ensure
Removal.
(See figure 2-2.)
a.
strips (13).
that two silicone rubber strips (13) and
(1) Remove hydraulic module, para-
twelve washers (12) are in position over
twelve studs (10).
graph 2-8 and 3-6 Air Intake Duct Assembly.
(2) Loosen hose clamp (1) and dis-
connect pneumatic hose (2) from elbow
(3).
Ensure that exhaust ejector clears
AGPU frame and insulation when re-
(3) Remove nut (4) and elbow (3).
moving or installing. Insulation
Remove
weld pins on exhaust ejector can
(4) Refer to figure 2-3.
screws (1) and washers (2) and remove
shred housing insulation.
Remove ejector
drain tube cover (3).
drain tube (4).
(3) Attach a rope or sling to lift
points (14) and carefully lower exhaust
(5) Remove V-band coupling nut (6,
ejector (11) into position on AGPU floor
figure 2-2), and slide V-band coupling
over studs (10).
(5) back toward engine (15).
Change 5
2-35
