TM
55-1730-229-34
AG
320A0-MME-000
35C2-3-473-2
TO
TM
1730-34/1
of the AGPU.
Note that the generator
removed as a unit without removal
(6) cannot be removed from the engine
of engine.
(9) without first removing the engine.
The engine is supported at two points by
a. Removal.
generator is supported at the rear by an
(1) Remove hydraulic module (para-
adjustable height generator support (7).
This allows aligning the engine exhaust
with the exhaust ejector inlet tube (see
Care must be taken when
(2) Remove inner air intake duct
removing the engine/generator, since the
by performing steps (4) through (8) of
lifting cable on the engine is forward
Cover engine air in-
of the combined engine/generator center
take with paper and tape.
of gravity. When lifting with a hoist,
(3) Disconnect pneumatic hoses/
down .
(a) Loosen hose clamps (1) and
disconnect hose (2) from manifold (3).
NOTE
(b) Disconnect tube assembly (4)
The hydraulic pump may be removed
Slide
from fitting on manifold (3).
tube assembly to the rear.
attached to engine, or it may be
Pneumatic Hoses/Lines Removal/Installation
Figure 2-6.
2-40