TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
M S 3 5 8 2 5 - 3 E hinge stock. Cut to
l e n g t h , and match drill rivet
holes.
Position panel as-
(3) Install.
s e m b l y and install with ten screws ( 1 )
a n d washers (2).
Pneumatic Hose Access Door.
(1) Remove.
Drill out ten rivets
(1) and remove door.
(2)
Repair.
(a) Repair door (3) by straight-
ening and painting.
(b) Replace latches (4) by
s t a l l i n g new latch. Rivet new latch.
o u t five rivets, and installing new flap
Rivet flap to door (3) and mount-
(7).
ing strip (6) using five rivets (5).
(d) Replace hinge (2) by drill-
ing out ten rivets (1), and installing
new hinge. Rivet new hinge.
NOTE
I f replacement hinge is not avail-
a b l e , one can be fabricated from
M S 3 5 8 2 5 - 3 E hinge stock. Cut to
l e n g t h , and match drill rivet
holes.
3-5.
F i g u r e 3 - 9 . Pneumatic Hose Access
Door Assembly
NOTE
(1) Inspect ejector inlet tube
(10) for cracks, or severe errosion
I f replacement hinge is not avail-
Replace if
(part of body worn away).
a b l e , one can be fabricated from
damaged.
3-13