TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(1) Remove lower connector of tube
(9) Remove remaining eleven nuts
(36) that hold top cover (12) on res-
assembly (10) from top of tee (18) at
ervoir (11).
front of low pressure filter head assem-
bly (22, figure 8-14). Remove and dis-
card copper seal.
(10) Carefully pry top cover (12)
off of reservoir (11) and withdraw top
from module.
(2) Remove upper connector of tube
assembly (10, figure 8-15) from elbow
Remove and
(11) Scrape reservoir gasket (40)
(2) at top of cooler (7).
off top edge of reservoir (11). Clean
discard copper seal.
all gasket and gasket cement residue
from reservoir (11).
(3) Withdraw tube assembly ( 10)
from module.
1. Remove reservoir top cover (12,
m. Remove tube assemblies (5 and 13,
figure 8-15) as follows:
figure 8-14) as follows:
(1) Loosen two nuts (31) on bolts
(1) Remove top connector of tube
assembly (13) from forward end of bulk-
(30) and slide rain shield (29) up and
Remove and discard
head fitting (47).
out of slots of front panel (33).
copper seal.
(2) Remove manual fill reducer
(2) Remove reducer (45) from rear
(35, figure 8-15) from elbow (37) on top
Remove
of reservoir. Remove and discard copper
end of bulkhead fitting (47).
seal.
and discard copper seal.
(3) Remove two bolts (34, figure
(3) Remove jam nut (41) from bulk-
head fitting (47).
brackets (35) on top of reservoir.
(4) Withdraw bulkhead fitting (47)
(4) Remove two nuts (36) that se-
from module.
cure brackets (35) to top of reservoir.
(5) Remove bottom connector of
-
tube assembly (5) from fitting (53, fig
(5) Remove two brackets (35).
Remove and discard copper
(6) Remove three bolts (37) and
seal.
washers (38) that secure bottom of ter-
minal board panel (39) to module frame
(6) Withdraw tube assemblies (5
(l).
and 13, figure 8-15), with assembled
check valve (56), from module.
(7) Remove three nuts (36) that
secure top of terminal board panel (39)
to top of reservoir.
n. Remove cooler (14, figure 8-14)
as follows:
(8) Carefully lift terminal board
panel (39) over top of reservoir studs
and pull panel forward just enough to
clear reservoir cover (12). Wiring
(1) Remove lower end of tube as-
sembly (11, figure 8-15) from elbow (2)
harness limits motion of terminal board
panel. Clip wire ties as necessary when
at bottom of cooler. Remove and discard
copper seal.
removing panel.
8-31
