TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
(4) Remove all four dust caps that
have chains (52) rivited to front panel
In the following step the support
(33).
bolts for the cooler will be re-
moved. Be sure to hold cooler up
(5) Remove forward connector of
while removing the last of the six
tube assembly (1, figure 8-15) from el-
bolts.
sure gauge (8). Remove and discard cop-
(2) Remove six bolts (41, figure
per seal.
8-14) with washers (42, 43) that support
cooler (14) on back of module frame (1).
(6) Carefully pull front panel
The rubber mounts (44) and nuts (45)
forward and turn it to the left. Wiring
should stay with the cooler.
harness limits motion of panel. Clip
wire ties as necessary when turning
panel.
The cooler fins are fragile and
q. Remove tube assembly (9, figure
bend easily. When withdrawing
can bend the fins. Use extreme
(1) Remove upper connector of tube
care when taking cooler from mod-
assembly (9) from bulkhead fitting (55,
ule.
ting on the left when viewed from rear
(3) Lift cooler and withdraw from
of module).
Remove and discard copper
seal.
module frame through the top.
o. Remove tube assembly (48, figure
(2) Remove lower connector of tube
(54). Remove and discard copper seal.
(1) Remove upper connector of tube
assembly (48) from tee (3). Remove and
(3) Withdraw tube assembly (9)
discard copper seal.
from module.
(2) Remove lower connector of tube
assembly (48) from fitting (54, figure
r.
Remove tube assembly (4) as fol-
8-14) on
rear of
main control manifold.
lows :
(3) Withdraw tube assembly (48,
(1) Remove upper connector of tube
assembly (4) from bulkhead fitting (56,
Loosen front panel (33, figure
ting on the right when viewed from rear
q
8-14) from module frame (1) as
follows:
Remove and discard copper
of module).
seal.
(1) Remove two bolts (47) below
(2) Remove lower connector of tube
the blue fill controls (50) on fill
manifold (51).
select manifold (58).
Remove and dis-
(2) Remove setscrew (48) in
RES-
ERVOIR select valve handle (49).
card copper seal.
(3) Remove RESERVOIR select valve
(3) Withdraw tube assembly (4,
figure 8-151 from module.
handle (49).
8-32