TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(3) Install and tighten three
(5) Install free (lower) end of
tube assembly (26, figure 8-15) on
bolts (75) that secure head assembly
(22) to frame.
adapter (28) at rear of high pressure
filter head assembly (27, figure 8-14).
Tighten hand tight.
Install accumulator (16, figure
8-14) as follows:
g. Install tube assembly (17, figure
(1) Insert accumulator (16) under
8-15) as follows:
horizontal shelf of module frame with
two cradle brackets (74) between accum-
ulator and shelf.
(1) Coat threads of fittings at
both ends of tube assembly (17) with
hydraulic fluid (MIL-H-5606 or MIL-H-
(2) Insert two u-bolts (71) under
83282) .
accumulator and up through holes in mod-
ule shelf.
(2) Install new copper seal (7C-
12) on bottom of tee (18) on front of
(3) Install a flat washer (73) on
low pressure filter head assembly (22,
each end of each u-bolt.
(4) Loosely install a nut (72) on
each end of each u-bolt.
(3) Install tube assembly (17,
front of low pressure filter. Tighten
(5) Turn accumulator (16) to line
hand tight.
Up match marks between accumulator and
u-bolt.
(4) Install new copper seal (7C-
Tighten nuts (72) on u-bolts
12) on fitting (69, figure 8-14) on side
(6)
of fill manifold.
(71).
f. Install tube assemblies (26 and
(5) Install tube assembly (17,
51, figure 8-15), with assembled tee (3)
8-14) on side of fill manifold. Tighten
as follows:
hand tight.
(1) Coat threads of fittings on
both ends of tube assemblies with hy-
(6) Torque connectors on both ends
draulic fluid (MIL-H-5606 or MIL-H-
of tube assembly (17, figure 8-15) to
83282) .
between 900 and 1,000 inch-pounds.
(2) Install a copper seal (7C-10)
on elbow (70, figure 8-14).
h. If removed, install check valve
(50, figure 8-15) on elbow on top of
reservoir select manifold (58, figure
(3) Install free (lower) end of
tube assembly (51, figure 8-15) on ac-
8-14) as follows:
cumulator elbow (70, figure 8-14).
Tighten hand tight.
(1) Inspect threads of both check
valve and elbow for damage or contami-
(4) Install a copper seal (7C-10)
nation.
on adapter (28, figure 8-15) on back of
high pressure filter head assembly (27,
(2) Coat threads with hydraulic
fluid (MIL-H-5606 or MIL-H-83282).
8-37
