TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
Torque tube assembly (8, figure
(6) Install lower connector of
on top of main control manifold (15) to
voir select manifold (58). Tighten hand
between 450 and 500 inch-pounds.
tight.
q. Torque tube assembly (8, figure
8-15) connector on
side of
swivel nut
(7) Torque connectors on both ends
tee (49) to between 450 and 500 inch-
tween 1,200 and 1,400 inch-pounds.
pounds.
Install tube assembly (9) as fol-
t.
lows:
In the following step the check
(1) Inspect threads on both ends
of tube assembly (9) and on elbow (54)
valve must be held stationary.
To torque the fitting on one end
without holding valve can cause
(2) Coat threads on both ends of
threads to strip.
tube assembly (9) with hydraulic fluid
r. Hold check valve (50) near the
(MIL-H-5606 or MIL-H-83282).
tube assembly (6) fitting and torque
fitting on tube assembly (6) to between
(3) Install a new copper seal (7C-
450 and 500 inch-pounds.
16) on the bulkhead fitting (55, fig-
8-15).
s. Install tube assembly (4) as fol-
lows:
(4) Insert tube assembly (9, fig-
(1) Inspect threads on both ends
of tube assembly (4) and on fitting (57,
(5) Install tube assembly (9) up-
per connector on bulkhead fitting (55,
Tighten
manifold (58) for damage and contamina-
tion.
hand tight.
(2) Coat threads on both ends of
(6) Install lower connector of
hydraulic fluid (MIL-H-5606 or MIL-H-
(54). Tighten hand tight.
83282).
(7) Torque connectors on both ends
of tube assembly (9) to between 1,200
(3) Install a new copper seal (7C-
16) on the bulkhead fitting (56, figure
and 1,400 inch-pounds.
8-14) and on
the fitting (57) on
side of
reservoir select manifold (58).
u. Install tube assembly (48) as
follows:
(4) Insert tube assembly (4, fig-
(1) Inspect threads on both ends
of tube assembly (48), bottom port of
(5) Install tube assembly (4) up-
per connector on bulkhead fitting (56,
Tighten
on rear of main control manifold for
hand tight.
8-40