TM 55-1730-229-34
AG 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(2) Coat threads on ends of tube
(14) Install manual fill reducer
assemblies (14 and 16, figure 8-15) with
(35) over seal (36) on elbow (37) on top.
hydraulic fluid (MIL-H-5606 or MIL-H-
Torque manual fill re-
of reservoir.
83282 ) .
ducer (35) to between 650 and 700 inch-
pounds.
(3) Install a copper seal (7C-8)
ab. Install tube assembly (10) as
on rear end of tee (44) on top of reser-
follows:
voir.
(4) Install a copper seal (7C-8)
(1) Inspect threads at both ends
on welded fitting (82, figure 8-14) on
of tube assembly (10), on elbow (2) at
top of cooler (7), and on top of tee
bottom plate of module.
(18) on front of low pressure filter
(5) Insert tube assemblies and as-
head (22, figure 8-14) for damage and
sembled check valve into module.
contamination.
(2) Coat threads at both ends of
(6) Install the connector of the
free end of tube assembly (14) on the
tube assembly (10, figure 8-15) with
hydraulic fluid (MIL-H-5606 or MIL-H-
rear end of tee (44) on top of reser-
voir. Tighten hand tight.
83282).
(3) Install a copper seal (7C-12)
(7) Install the connector of the
free end of tube assembly (16) on the
on the elbow (2) at the top of cooler
(7) and on top of tee (18) on low pres-
welded fitting (82 , figure 8-14) on
Tighten hand
sure filter.
bottom plate of module.
tight.
(4) Insert tube assembly (10) into
(8) Torque ends of tube assemblies
module.
to between 450 and 500 inch-pounds.
(5) Install upper connector of
ad. Install tube assemblies (38 and
tube assembly (10) on elbow (2) on top
of cooler (7). Tighten hand tiqht.
43) and assembled check valve (39) as
follows:
(6) Install lower connector on tee
(18) at front of low pressure filter.
(1) Inspect threads on ends of
Tighten hand tight.
tube assemblies (38 and 43) and on front
port of tee (44) on top of reservoir for
damage and contamination.
(7) Torque both connectors of tube
assembly (10) to between 900 and 1,000
inch-pounds.
(2) Coat threads of tube assem-
blies with hydraulic fluid (MIL-H-5606
or MIL-H-83282).
ac. Install tube assemblies (14 and
16) and assembled check valve (15) as
(3) Install copper seal (7C-8) on
forward port of tee (44) on top of res-
follows:
ervoir.
(1) Inspect threads at ends of
(4) Insert tube assemblies and as-
tube assemblies (14 and 16), on tee (44)
sembled check valve into module with up-
on top of reservoir, and on welded fit-
ting (82, figure 8-14) on bottom plate
per connector near tee (44) on top of
of module for damage and contamination.
reservoir and lower connector near where
8-43
