TM
55-1730-229-34
AG
320A0-MME-000
TO
35C2-3-473-2
TM
1730-34/1
(9) Install free end of tube as-
Tighten
sembly (12) on reducer (40).
be (when installed).
hand tight.
(5) Install upper connector of
tube assembly on tee (44) on top of res-
(10) Install free end of tube as-
Tighten
ervoir.
sembly (25) on adapter (30).
inch-pounds.
hand tight.
(11) Torque ends of tube assemblies
ae. Install tube assemblies (12 and
(12 and 25) to between 650 and 700 inch-
pounds.
nents (42, 46, 40 and 53) as follows:
af. Reassemble high pressure filter
as follows:
(1) Inspect threads on ends of
tube assemblies (12 and 25), of bulkhead
fitting (42), and of reducer (40) and
(1) Install packing (28, figure
8-14) on
top of
labeled HIGH PRESSURE
the front of adapter (30) on front of
filter element (25).
(2) Insert high pressure filter
(2) Coat threads on ends of tube
ter head assembly (27).
on both ends of bulkhead fitting (42),
with hydraulic fluid (MIL-H-5606 or MIL-
(3) Install packing (26) into re-
H-83282).
cess in high pressure filter bowl (24).
(4) Install high pressure filter
(3) Insert (from rear of module)
long end of bulkhead fitting (42) into
bowl (24) into high pressure head assem-
bly (27).
remaining hole in rear of module.
ag. Reassemble low pressure filter
(4) Install and tighten jam nut
as follows:
(46) on long end of bulkhead fitting
(42) on inside of module.
(1) Install packing (23) on top of
labeled LOW PRESSURE filter element
(5) Install copper seal (7C-12) on
long end of bulkhead fitting (42) on in-
(20).
side of module.
(2) Insert low pressure filter
(6) Install reducer (40) on long
element (20) up into low pressure filter
head assembly (22).
end of bulkhead fitting (42) on inside
of module.
(3) Install packing (21) into re-
cess in low pressure filter bowl (19).
(7) Install one copper seal (7C-
10) on reducer (40) and one copper seal
(4) Install low pressure filter
(7C-10) on adapter (30) on front of high
bly (22).
(8) Insert tube assemblies (12 and
25. figure 8-15) and assembled compo-
ah. Install front panel (33, figure
8-14) on
module frame (1) as
follows:
nents into module.
8-44