TM 55-1730-229-34
AC 320A0-MME-000
TO 35C2-3-473-2
TM 1730-34/1
(2) Withdraw tube assembly (11 ,
8-14) from module frame (1) as
follows:
u. Remove tube assembly (8, figure
(1) Back off swivel nut (on swivel
it will go easily. It may not back off
of all the threads of bulkhead fitting
(1) Remove rear connector of tube
assembly (8) from swivel nut tee (49).
Remove and discard copper seal.
raised in a later step.
(2) Remove four bolts (60) and
(2) Remove forward connector of
washers (61) that insert horizontally
tube assembly (8) from fitting (64, fig-
through module frame and into reservoir
ure 8-14) on top of main control mani-
Remove and discard copper
brackets at center front and center
fold (15).
seal.
rear.
(3) Remove four bolts (18) and
(3) Withdraw tube assembly (8,
nuts (62) that insert vertically through
reservoir flanges and module frame at
each corner of reservoir.
v. Remove tube assembly (1, figure
(4) Gently pry end (on module's
left side) of reservoir up out of frame.
(1) Remove lower connector of tube
assembly (1) from small fitting (65)
While prying, check that swivel nut on
manifold (15). Remove and discard cop-
If connection is not free, finish back-
per seal.
ing off swivel nut.
(2) Withdraw tube assembly (1,
w. Remove load valve solenoid (66,
Use extreme care in the following
step not to damage threads of bulk-
head fittings under reservoir.
(1) Trace wires (one black and one
(5) Withdraw reservoir out through
Clip wire ties be-
the module's left side.
board panel (39).
(6) Remove and discard copper seal
wires can he removed.
on bulkhead fitting (59).
(2) Loosen screw and disconnect
Remove tube assembly (11, figure
t.
black lead from TB2-D2.
(3) Loosen screw and disconnect
(1) Remove upper connector of tube
white lead from TB2-4.
assembly (11) from fitting (63, figure
8-14) on
main control manifold's right
(4) Pull load valve solenoid leads
free of module harness.
side.
8-33